hi thanks for your reply, I have not been able to connect with ardurino to install firmware, it is my intension to upload sprinter but I canot connect even with te serial moniter option entering the M115 comand fails to respond. In frustration I downloaded Termite and when I run that it comes up with com8,115200bps,no handshake pronterface runs perfectly until i press connect button and then hangby papakel - General
Hi all, I am a complete retired newbee, I have built a cnc router and got that working and now progressed to 3d printing project, I have built a printer from gathered bits and bobs, purchased stepper motors and a self assembly sanguinololu 1.3a kit complete with steper motor plugins I carefully assembled this kit following detailed instructions on Wiki, and would be so bold as to say it looks finby papakel - General
Hi all, I am a complete newby I bought my red self assembly kit from Ebay scitechsupplies made it up as per wiki all seems fine, when i plug in to usb the led lights, I installed the FTDI driver but I canot connect to the board with either ardurino 0023 or pronterface, the bootloader is supposed to be pre-installed but my doubts are growing so I tried to burn the bootloader again useing ardurinoby papakel - Sanguino(lolu)
Hi I am also a newbi my problem is that altough I can connect with ardurino and upload sprinter firmware I cannot get pronterface to connect, the screen shows the word connecting and hangs there although if I remove the usb cable pronterface goes balistic with error messages too fast to read. The port is comport 8 and I have tried all baurd rates from 9600 up to the maximum my configoration.h isby papakel - Sanguino(lolu)