Quoterepetier Of course it does not work. I told you, you need to modify the pins. In ui.h you search FEATURE_CONTROLLER == 5 #define UI_ENCODER_A 7 // pins the click encoder are connected to #define UI_ENCODER_B 22 #define UI_RESET_PIN 32 // single button for reset #define SDCARDDETECT 49 // Set to -1 if you have not connected that pin #define SDSS 53 // Chip seby The_Don - Repetier
Quoterepetier Not sure what you mean with "I have my board selected correctly in arduino IDE" since that board was not supported until now. Just uploaded an update with MOTHERBOARD 65 for Azteeg X1. After selecting the viki it will not compile since the viki is configured for Azteeg X3 which has pins that do not exists in the X1. You then need to change the pins for viki in ui.h Hi repetier, thaby The_Don - Repetier
Quotetllado Did you have any problems getting 0.91 to compile for Azteeg x1? I haven't been able to do it so far. 0.83 compiles just fine, but 0.91 is giving me never-ending errors. Yeah, .91 compiles OK for me. I have been using it for a while.by The_Don - Repetier
Gday, Thanks, for the reply. I tried resetting the board and it still does not work after the reset. With .91 firmware, after compile and upload, the printer won't communicate with the PC if I set FEATURE_CONTROLLER to 5( for VIKI). If I set it FEATURE_CONTROLLER to 0 it communicates fine, but I obviously have no LCD. I am trying to compile the latest .91.5 firmware and am getting the followingby The_Don - Repetier
Gday Peter, It seems you have this working with marlin. Have you had any success getting it to work with repetier. I have been searching and it seems there are issues with 1284 based boards and I2C in repetier. Thanks, Donby The_Don - Next Wave Electronics Working Group
Hi, I am not able to get the above combination to work using repetier (.91) firmware. I have tried Marlin and it works fine. I would much rather use Repetier though I also understand that the Azteeg X3 + VIKI works fine with Repetier. Can anyone shed some light on this issue please? Thanks, Donby The_Don - Repetier
I have experimented further and found that my hardware works OK with Marlin firmware. Display starts up and shows me the printer status etc. I also found this thread that seems to suggest that I2C is broken in Repetier for 1284P based boards (like my Azteeg X1) but not for 644P boards. Hoping a solution can be found.by The_Don - Repetier
Hi, I have constructed a clone of VIKI (Adafruit RGB LCD shield based) from circuit diagrams and attached it to Azteeg X1 board. I tested the display with the 'Hello World' sketch from Adafruit and it displays OK and shows on the display what buttons I pressed. From this I deduce that the hardware is OK. I changed the pin assignment in ui,h for controller 5 for my board. (They are only for the roby The_Don - Repetier
Hi all, My first post here, so be gentle... I am researching buying a Prusa i3 and am slightly concerned about printing objects with voids or overhangs. Is there any way of extruding a sacrificial filler into voids to support the material that is being printed? You would obviously need a 2nd extruder for this. Maybe a material that has a much lower melting point and could me melted away, or solubby The_Don - Plastic Extruder Working Group