Show all posts by user
All of China!
Page 2 of 2
Pages: 12
Results 31 — 38 of 38
Hi, i had a problem in a reprap host program. When i try to run a XYZ axis position to test my mendel than my computer was getting dead (no response) at that time when i was click a "go" buttom in the XYZ control winodws. Can anyone can tell me what is the problem ?
My computer setting as follows.
1.) I was follows and I did a "Select Preferences->Globals->CommsDebug " and i didn't found
by
tv7957ht
-
RepRap Host
Do you mean just turn the USB/TTL cable which is a side connected to extruder board upside down as normal ? if i plug that cable to extruder board the debug red led dont flicker any more.... ist correct ? Sorry. until to now, i have no idea how to fix this problem...... can you tell me more detail how to fix it ?
by
tv7957ht
-
Firmware - mainstream and related support
Hi. i was just finished my self-building PCB board... w/ motherboard and extruder board. I was completed burn a bootloader for both after that i was follow your instruction and completed to uploading a firmware to motherboard. However when i try to do the same way to upload firmware to extruder board i found this error at arduino IDE - 0018
"avrdude: stk500_paged_write(): (a) protocol error, ex
by
tv7957ht
-
Firmware - mainstream and related support
Hi. i was just finished my self-building PCB board... w/ motherboard and extruder board. I was completed burn a bootloader for both after that i was follow your instruction and completed to uploading a firmware to motherboard. However when i try to do the same way to upload firmware to extruder board i found this error at arduino IDE - 0018
"avrdude: stk500_paged_write(): (a) protocol error, exp
by
tv7957ht
-
Sanguino(lolu)
Hi, thank you for your advise.....by the way i also found a page "http://sanguino.cc/troubleshooting" and there also shown a instruction how to burn a bootloader on avrdude and i had solved a problem. However, when i was got this problem I was trying and searching a lot of method and got fail many times, now i had another new problems is i make a wrong way to burn a 2 chip by using a fuse burning
by
tv7957ht
-
Firmware - mainstream and related support
I was build a Sanguino board by myself and when i want to build a bootloader from arduino IDE 0018 and AVRdude it was show error as follows.
I'm using a "USBtinyISP" ---
and i was follow instruction by reprap site. ---
-----------------------------------------------------------------------
When i using "Arduino IDE0018" its shown
"Error while burning bootloader."
avrdude : Expected signature
by
tv7957ht
-
Firmware - mainstream and related support
你好..我是來自香港
我已經入手了一台MakerBot現正嘗試打印Mendel的零件.
有與趣的話可到我blog交流一下
by
tv7957ht
-
China + RepRap 用户组
Page 2 of 2
Pages: 12