Using Repetier firmware Dev. 1.0.1. The probe is wired to Radds servo block-"servoPWM1" and "z min endstop" as per manufacturer. 5v servo block is powered by voltage converter from 12v bus to regulated 5v. The probe will run self-test when the printer is first powered on-shows steady red led. It will also go into an alarm state if self-test is interrupted-shows blinking red led. In configurator,by Batteau62 - General
Update: Using Repetier firmware Dev. 1.0.1. The probe is wired to Radds servo block-"servoPWM1" and "z min endstop" as per manufacturer. 5v servo block is powered by voltage converter from 12v bus to regulated 5v. The probe will run self-test when the printer is first powered on-shows steady red led. It will also go into an alarm state if self-test is interrupted-shows blinking red led. In configby Batteau62 - RAMPS Electronics
Hi, I'm not a total newbie, but not well versed in electronics. I have a number of questions I'll post as seperate discussions. I appreciate any help or advice. Thank you in advance! Trying to set up a large format cartesian printer. Arduino Due with Radds and V2 extension board, 24v power supply, Three z axis steppers, two on the right side, one on the left. I'm planning to use the bl touchby Batteau62 - General
I'm using Repetier firmware. But even before firmware, I'm searching for how to physically connect the servo block on the Radds to power the bltouch? Is it controlled in firmware? As I said in the embedded link above, "I'm not a total newbie, but not well versed in electronics." Thanks for any help.by Batteau62 - Controllers
I have been trying to find more info on the servo block on the Radds? What did you determine was the best way to do this? Here is a link to a thread I started with my information: Any advice, diagrams, specific information on this topic would be much appreciated. Thanks in advance!by Batteau62 - Controllers
Hi, I'm not a total newbie, but not well versed in electronics. I have a number of questions I'll post as seperate discussions. I appreciate any help or advice. Thank you in advance! Trying to set up a large format cartesian printer. Arduino Due with Radds and V2 extension board, 24v power supply, Three z axis steppers, two on the right side, one on the left. I'm planning to use the bl touchby Batteau62 - RAMPS Electronics