Show all posts by user
Page 2 of 2
Pages: 12
Results 31 — 33 of 33
I am getting ready to order some stuff to upgrade my heated bed / build platform and replace my smooth rods with metric ones but I have a few questions...
Right now I have a slightly over sized i2 sae prusa from makerfarm.com kit (MK headbed which is small for the room I have, 5/16 smooth rods). I have already replaced the Z axis - 5/16 threaded rod with 1/4 acme(2 nuts each side w/spring) &
by
6of1
-
General Mendel Topics
I'm getting ready to print up &
I got the newest files from Gregs
But now I'm a bit confused. At this time I have 2 questions (sure to be more)
1. I am using SAE vitamins (5/16" smooth & 1/4" ACME) with my SAE Prusa v2 kit from makerfarm. In Gregs "configuration.scad" I see:
// PLEASE SELECT ONE OF THE CONFIGURATIONS BELOW
// BY UN-COMMENTING IT
// Uncomment for metric settings
//
by
6of1
-
General Mendel Topics
I have the Printrboard Rev C and right now a MK1 heatbed. I built my machine a little bigger then specs on the wiki. Mechanicly its working fine but my MK1 heatbed/table is much smaller then the amount of travel I have. Are there any other heated bed options that will work like the MK1 plugged into the Printrboard?
the Mk1 (with my piece of glass) gives me a 203mm x 203mm bed. I have calculated
by
6of1
-
Controllers
Page 2 of 2
Pages: 12