Hi and thx DC42. Tested 0.59 and 0.75 for some prints now and that's it i go web control only now. BIG thx for the fantastic jobby ran - Ormerod
I have a similar design on my nozzle but i have tilted the wale at the nozzle 45 degree to clear the heater cablesby ran - Ormerod
Yes and i lover the Bridging speed then it get it right. whit the hi speed it 1 layer never get to the sides then the 2and Bridging fine do not know whyby ran - Ormerod
Think my red wire are at the same side on the hotbed but at the other side on the motherboard (flat cable)by ran - Ormerod
I print on kapton. When i remove print i spray some electric component test cooling spray on them then i can take them of whit my hand (-50 Celsius)by ran - Ormerod
Hi Carsten ! I hang a bucket in the hook and hold the other end in the outer corner (arrow at the picture) and added water in bottles to the bucket. I only have a household scale so i needed to split the load up. Johnby ran - Ormerod
Hi all ! I am new here on this forum and terrible on English but i make a go for it. First Thanks for all god info from this forum. I made a test whit different extruder temps to see how strong they get. Settings: Z0.24 perimeters 0.75 Filament : Filament print (get whit the ormerod) Tested temps 155 160 165 170 175 180 185 190 195 200 205 155-170 bad bonding. 175- 180 ok but did not tby ran - Ormerod
Hej Göteborgare som använder Reprap ormerod. åå va gött den gårby ran - Sweden, Gothenburg RepRap User Group