HiTreth, I had all the items on your snag list, except my belt sprockets were a good push fit. The ther nut problem I had was getting the captive nuts into the printed slots on the hot end bracket (these needed a lot fo force to insert especially since I didn't do them until the whole thing was built - it might be worth inserting all of these prior to starting the build). The two pieces you'veby rayhicks - Ormerod
I think I've done most of that Ian - I'll verify tomorrow, particularly re M503 response and trying a new SD card, but as I've said here and in irc my duet doesn't seem to execute the config.g (even after reformatting the SD) - maybe you can send Adrian or the board you've got working (or better still both) in my direction tomorrow if the steps you suggest fail on my machine (sorry for jumping iby rayhicks - Ormerod
@DeuxVis - he did start that post by saying Quotedroftarts I just thought I'd address a couple of things in this thread, though I should point out that this is my opinion, not those of RepRapPro! which means to me that at least he thought that people might realise he worked for RepRapPro, and wanted to distance his opinion from that organisation while recognising a link to it, and would would waby rayhicks - Ormerod
@pault - I measure a steady 100mV on C74 when powering only from the 12V IN and with JP9 in place (with no jumper it floats with hum in the low mV). Measuring the in-circuit powered-down resistance of R60 and R61 gives me 720R for R61 (750R in the schematic), and short circuit for R60 (3k92 in schematic). The output of the regulator is governed by R60/R61 so maybe the apparent short on R60 isby rayhicks - Ormerod
@Carnivalius and markbee - thanks - this makes sense, I still hadn't moved my Z axis post over enough, so the head couldn't reach the piece of plastic - seems to work fine for me without white tape. I've found the Z-probe to be pretty sensitive to angle - it's possible to get pretty good readings (between 600 and 700) direct off the Kapton tape at 3-4mm if it's pointing straight down - I removedby rayhicks - Ormerod
Hi Markus, I've found that manually sending G555 P2 (emulate marlin) kicks it into gear a bit - this command should be executed when config.g runs, which leads me to guess that config.g isn't running on startup. Once I've entered G555 P2 I can "print" config.g and other files, running config.g in this way still doesn't bring up the ethernet connection though Rayby rayhicks - Ormerod
Hi Treth - indeed, when I built it there was no measurement in the instructions (I just roughly centred the column), when I put the rs box on I had to move it to the right a bit (but moved it too much) and I didn't go back to the z-axis mounting page to notice that it should be 125mm from the right - thanks for pointing out this change in the instructions I agree on the safeguard stuff - after iby rayhicks - Ormerod
I've hit many of the issues already described in this thread, and posted them to two threads on emakershop fourms over the weekend. Some of my issues were resolved by flashing the firmware with Saturday's build, but I still can't get the Ethernet connector to come live so haven't been able to use the web interface to control the printer. I've had no luck printing with pronterface - although thisby rayhicks - Ormerod