I'ts fixed. I add a cooling fan to the RAMPS and raised the VREF the clicking sound disappeared and everything works perfect now! Thanks for the reply'sby jokke0066 - Reprappers
I'm using 2 z-axis motors So I raised VREF of my Z-axis stepdriver, now I sometimes hear a clicking sound from my motors (Higher VREF faster clicking, lower VREF slower clicking) I also noticed a very small left-right movement of my rods. But I have still the same problem. I'll try to swap my stepdrivers to check if that's te problemby jokke0066 - Reprappers
Cura generates 33 layer with a layer height of 0.3 that gives 9,9mm so thats correct.by jokke0066 - Reprappers
I have a problem with my printed parts. A test cube printed just 7mm high instead of 10mm If I manually check my z axis by click the higher Z-axis 10mm button in reptier the nozzle measures perfect 10mm from the bed. So my steps/mm is right. It's only appearing when a part gets printed. I use a custom made 3D printer with 2 ATX supply's 1 for Heated Bed and the other for the electronic, so thereby jokke0066 - Reprappers
I had problems with retraction, a blob of molten PLA get pushed back and get clogged in the cooling part of the extruder because it get hard.by jokke0066 - Reprappers
I know, but thats not simple enough. I just want 6 buttons when I push te printer move's. I don't want a menu or something like that.by jokke0066 - Reprappers
I want to make my own simple remote controller (with a short cable to my controller). I just want to move all the axis without every time going to my pc to click the move buttons. I'm using Marlin firmware on a RAMPS 1.4. Do's someone have an idea? grtzby jokke0066 - Reprappers
Probleem opgelost, #define TEMP_0_PIN bevond zich in de pins_RAMPS_14.h file dat stond nergens uitgelegd op de wiki page grtzby jokke0066 - Electronica
Hallo iedereen, Ik zit met volgend probleem, ik heb me een thermokoppelbord v1.0 en een Thermokoppel type K van 123-3D aangekocht. Ik heb alles aangesloten op men RAMPS 1.4 via AUX-1. Het extern bordje krijgt 5v dus dat is inorde. In de MARLIN Firmware heb ik onder config.h #define TEMP_SENSOR_0 -1 Dat is alles wat ik heb gedaan. Ik lees dan 499,5°C af. volgens http://reprap.org/wiki/Extby jokke0066 - Electronica