Thank you, that was it. I started over and reinstalled the IDE and then used a fresh copy of Marlin. Compiled with no changes, it worked, copied the folgertech config from the example configurations and compiled with no problems. Made the changes needed for my upgraded stepper drivers and it worked as well. The only difference I can tell from previous attempts at starting over was I edited inby Fpeebles - RAMPS Electronics
Everyone, I can't get Marlin to compile. I've tried both Arduino IDE 1.6.8 and 1.8.3. I've downloaded a clean copy of Marlin 1.1.x Release version and the only modifications I've made to it where my stepper motor values since I upgraded to DRV8825's when I bought it. I'm running on a win 10 system. I keep getting the following error when I try to compile and validate: ========================by Fpeebles - Firmware - Marlin
Everyone, I can't get Marlin to compile. I've tried both Arduino IDE 1.6.8 and 1.8.3. I've downloaded a clean copy of Marlin 1.1.x Release version and the only modifications I've made to it where my stepper motor values since I upgraded to DRV8825's when I bought it. I keep getting the following error when I try to compile and validate: ========================================================by Fpeebles - RAMPS Electronics
Thanks everybody for the advice before. Got everything together and ready to go. When I tried printing out the 5mm calibration steps everything seems to go great. Printer homes, Bed heats up, Extruder starts to heat gets to 80c and then just stops heating. I tried printing from repeteir as well as SD card and same behavior. When I manually turn on the extruder heater it comes up to temp just finby Fpeebles - Prusa i3 and variants
So I figured out my issues. First I had to move the x-axis endstop to the left side so that it is a MIN type as well as the others. Also I hadn't taken into account that I am using 1/32 drivers so none of my step settings were correct. Now to learn how to level the bed and start melting some plastic. Thanks for your help @mopar99 I agree now that I've figured out these issues I am going to looby Fpeebles - Prusa i3 and variants
Thanks but I can't get RC-8 to compile and running a Release Candidate may be out of my league. I'd like to get the printer up and running on stable before I start going bleeding edge. Thanks again.by Fpeebles - Prusa i3 and variants
Thanks in advance for the help. I've finished building my printer but I'm having zero luck getting it to function. I've broken this down to the following issues: 1.) When I run M119 my Y_max endstop shows Triggered 2.) None of my axis will move more than half way and Y-axis will move in one direction but not the other. Issues I've had and resolved: 1.) Motors moving in the wrong direction - Reby Fpeebles - Prusa i3 and variants