Is it possible to remove all of the // commented out sections of Marlin to trim it down? For Example under LCD Section. Can I remove the code for all of the other LCD that dont apply to my 3d printer?by RanchoMattPS - Firmware - Marlin
I recently got my FT 2020 i3 with BL Touch up and running. First go to GitHub and download the Marlin 3dPrinter Tool. It is extremely useful when calibrating the BL Touch. I will attach my configuration.h file that i used so you can compare it to yours. Good luck.by RanchoMattPS - Prusa i3 and variants
Mark, On the Google drive link for the Folgertech 2020, under Beta Firmware there is a zip file titled FT-2020-FULL_LCD, unzip this to your pc.There will be a file called FT_2020_FULL_LCD.ino , double click this, it will open in Arduino IDE. Choose your board and COM port and upload. That is all. Close Arduino IDE your LCD will reboot with the Folgertech menu. Next proceed to Repetier for morby RanchoMattPS - Prusa i3 and variants
#1 Ok I have my FT 2020 built, I can move all axis using the LCD controller. I can home/control all axis in Repetier. I slice and print and nothing happens. I can see it sending the gcode but nothing ever moves. My extruder heats up fine. My heated bed will only heat up to 35C. But even if I lower the heat temp to under 35C nothing moves. I have checked my stepper drivers and they are aby RanchoMattPS - Prusa i3 and variants
I just finished my build and had a few questions #1 Why is the Z carriage under the 3rd stepper driver plugged in backwards? #2 Step 21-2 picture shows Black + Red - but reads Black - Red + which is correct? #3 I am using the Full LCD so the firmware updater i use is FT-2020 Full LCD correct? #4 Step 7 config manual, doesnt read Folger Tech under author mine reads author: SW &amby RanchoMattPS - Prusa i3 and variants