these are not available in latest firmware,by rohit939 - Firmware - Marlin
hello, i'm trying to use servo i configured everything like offsets from extruder, probing points, when i give G29 command servo extends and then probes to first point, and then it doesnt retract and keeps moving from one point to another i want to retract my servo at every probing point so i can avoid any crash. please help, my servo doesnt retract like it happens in this videoby rohit939 - Firmware - Marlin
here's the formula. steps_per_mm = (motor_steps_per_rev * driver_microstep) / thread_pitch according to this i'm getting 2560 steps so what should i write instead of 400? calculations? and i'm talking about threaded rods not lead screw.by rohit939 - Mechanics
in marlin its #define DEFAULT_AXIS_STEPS_PER_UNIT {100,100,400,100} // default steps per unit for Ultimaker i think 400 is for z axis, still dont know what to change ? and what to write can you guys help me with full calculation method?by rohit939 - Mechanics
hello i want to configure steps in marlin but dont know how to and what to change. i am using these threaded rod ? instead of lead screw, lead screw rods are way more expensive than threaded rod here. please help.by rohit939 - Mechanics
i'm using marlin firmware and ramps 1.4 stepper motors are working as usual but whenever i click home x on repitier host the motor turns in forward direction not reverse, and motor does not turn complete it takes on 5-10mm steps. dont know what is wrong with it any help will be highly appreciated and i'm new to this i'm using these endstops Got them working. deleting it.by rohit939 - Reprappers