FAN button is not working. If I enter M106 P1 S1 in Console, fan is switched on. But Fanbutton on the Panel is doing nothing... Extrude button not working also. Think it´s because of beta?by critical_limit - Controllers
Hi all, I can´t find the thread where somebody said that NPN Prox. Sensors can directly connected to the Duet. Maybe someone can help me out. How to connect a NPN to the Endstop connectors of the Duet 0.8.5? Or was it PNP??? Can´t remember, but someone did it without any other electronics. Outer pins are used for a normal switch. Is the inner pin 12V (24V) ? Maybe somebody can explain how to coby critical_limit - Controllers
1.12 b2 is very nice. working perfect on my duet 0.8.5. Request for future releases: Language support. Not only Keyboards in different languages, but anything in the selected language as well. Like in the webinterface. possible? cheers Dirkby critical_limit - Controllers
Is there somebody who can give me a example how to use the M668? If I understand right, it can compensate uneven beds with calculations based on 40 probe points? If so, how to probe these 40 points and store them? In a file? David, can you explain please and give a example how to setup and use? Thanx Dirkby critical_limit - Delta Machines
thanx David. I will check Github now every day... ;-)by critical_limit - Delta Machines
ok, now I can switch the fan on and off with M106 S0 or M106 S255. But M106 S254 stops the fan. On the smoothie the same fan is working and can be pwm controlled. Is it a question of the frequency? Can I change pwm frequency on the duet as i can on the smoothie?by critical_limit - Delta Machines
aah! That did the job! Perfect! Thank you very much!by critical_limit - Delta Machines
Thanx David. Fan is the same as I used with my E3DV6 and the smoothieboard. Working with PWM there. What I dont understand is, that M106 P1 S1 set the Fan to off. While M106 P1 S0 to on. So its vice versa. S0 is 100% and S1 is off?? Hm, currently I have a print running (which is absolutly fantastic with the Duet and the IR-probe!!). But when it´s finished I will check if I can figure it out...by critical_limit - Delta Machines
Hi all, I´m quit new to the Duet and I´m installed a Layer Fan to my Kossel (first time due to only used ABS) I can´t get it work. Is M106 not the right command at the dc42-fork? M106 P1 S1 set the Fan to off. M106 P1 S0 set it on. but what about regulation? 50%, 75%? And how to tell S3D to use specific commands for this? Can anybody help me out? thanx Dirkby critical_limit - Delta Machines
Quotedc42 On my delta, the reproducibility is generally +/- 1 microstep, which is 12.5um on that machine. That´s my target! Thanx for the infoby critical_limit - For Sale
David, can you give a statement to the accuracy of your IR Board? Whats about repeatable results when probing? With my mechanical switches I have repeatable results between 0-5 steps on z-height. And thats quite good. But I want a solution without touching the heatbed. Any information about that? cheers Dirkby critical_limit - For Sale