The request has been fulfilled. Thank you.by mark2 - Wanted
For clarification: Greg's Hinged Accessible Extruder The part is labeled "large gear.stl" at the bottom.by mark2 - Wanted
I need a Wade's large printed in ABS, preferably 50% or greater infill. PM for details. I will post an update after I receive shipping confirmation and paypal someone.by mark2 - Wanted
yes, that's exactly how I connected the wires. The positive was directly from the psu 12v2 4 pin molex and ground was only on d8 negative side.by mark2 - RAMPS Electronics
I just got a 2 12v rail psu and connected 12v1 to the hot end and motors while 12v2 was connected to my heated bed, grounded through D8 -. The bed seemed to get hot, but it was also uncontrollable. Setting the bed temp to 0 and it climed from 50c to 84c before I pulled the plug. After a few restarts I finally got a hot end around 210 and heated bed around 55. About 3 hours later I go to printby mark2 - RAMPS Electronics
Every once in a while (once or twice per layer) my extruder just buzzes and the gears don't move, then normal operation continues. If I manually send g-codes it will consistently buzz at 1200 speed and not move. I've set all my flow rates so the g-codes don't send any speed higher than 1080 (checked gcode manually), but I still get the buzzes every so often. I've also turned my extruder motorby mark2 - General
US, Michigan. Interested in 2.by mark2 - For Sale
Looking to pop in a replacement for my fried ramps. Want sanguinololu or gen6. Send PM. I can't solder, so no kits please.by mark2 - Wanted
You can definitely get smoother edges than what you see online, but people like to show off the calibration of their machines via unaltered productions. That's why almost everything that you see has ridges on it. Either that or they post a pic as soon as it's done but before they do final clean-up on it. But, there's also this un-touched-up print from a makergear mosaic machine:by mark2 - Reprappers
stackman Wrote: ------------------------------------------------------- > if the build is too > involved I know that I will not have the time to > see it through to completion. Then you only want to look at Prusa variants. You will probably need a soldering station, wire strippers, a vice or a huge c-clamp ... these builds are not simple. If you are not deft at working with low voltaby mark2 - Reprappers
Looks like the first unit shipped with elec/motors, but this kit does not. If you can bundle either remaining kit with elec/motors send me a P.M.by mark2 - For Sale