I can't figure out how to correctly place the shunts (jumpers) on my SKR v1.4. I have a set of 4 DRV8825s and a set of TMC2208s that I can use. Where should I place the shunts for my Kossel to work? I don't know if I should go standalone or UART. Whatever it takes to get me printing again. TIA

---

Anycubic Kossel Linear Plus w/SKR V1.4 Turbo
Folgertech 2020 i3 w/SKR V1.3

Firstly the image you provided is for a SKR 1.3 and the jumper on a SKR 1.4 are different.

For the DRV8825s you must use step and direction mode.



For the TMC2208s you can run in step and direction mode as above. Or enable UART mode and allow the software to control the stepper drivers fully