Welcome! Log In Create A New Profile

Advanced

Delta printer ball joints, let's talk!

Posted by 3Dpassion 
Forum List Message List New Topic
dc42
Re: Delta printer ball joints, let's talk!
December 25, 2019 04:00AM
If your printer runs RepRapFirmware then small differences in scale can be corrected using M579.


Large delta printer [miscsolutions.wordpress.com], Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
Reply Quote
Ohmarinus
Re: Delta printer ball joints, let's talk!
December 25, 2019 06:08AM
Okay, I will start a new topic that is specific to this printer so it's easier to get some help instead of replying under other's topics.

http://www.marinusdebeer.nl/
Reply Quote
Page 2 of 2    Pages: Previous12
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login