High speed, high volume flow rate printing October 14, 2018 09:05AM |
Registered: 8 years ago Posts: 622 |
Re: High speed, high volume flow rate printing December 01, 2018 02:18AM |
Registered: 8 years ago Posts: 5,232 |
Re: High speed, high volume flow rate printing December 09, 2018 12:10PM |
Registered: 8 years ago Posts: 622 |
Quote
o_lampe
I must've missed that thread. Very impressive
What if you'd use one NEMA23 extruder instead of three Bondtech ( $$$ )? Approximately same weight or even less.
Would it rip out the Bowden tube?
Would it melt fast enough? (only one meltchamber instead of three). Maybe a longer melt chamber would do the trick...
Re: High speed, high volume flow rate printing December 09, 2018 07:26PM |
Admin Registered: 13 years ago Posts: 7,005 |
Re: High speed, high volume flow rate printing December 10, 2018 03:04AM |
Admin Registered: 16 years ago Posts: 13,891 |
Re: High speed, high volume flow rate printing December 10, 2018 04:50AM |
Registered: 6 years ago Posts: 1,007 |
Quote
VDX
... hmmm ... MIT managed to get a patent on "laser-preheating" the filament, what we were discussing here in the forum 10 years ago ... so the patent attorneys didn't find the "prior art" infos
Re: High speed, high volume flow rate printing December 10, 2018 05:15AM |
Registered: 8 years ago Posts: 622 |