Welcome! Log In Create A New Profile

Calibration print ok but it needs some help.

Posted by Floyd

Floyd

Calibration print ok but it needs some help.
January 24, 2014 09:35PM

Registered: 10 years ago
Posts: 770

Printed this out from Thingiverse for a little testing on the printer.
Its a Makerfarm 8" i3 with a .4 Magma head printing ABS at .3 layer height. Im also using Slic3r and Pronterface to create and send the Gcode.

Im ok with the box but the small stuff and the cylinders have some issues. It also looks like it blobs when it starts a new line of filament. Its great once it gets going but starting blobs a nice drop before it goes. My retract is at 1.2mm at the moment.

I hope you all have some suggestions for me to try to get these little issues taken care of.

Reply Quote

gmh39

Re: Calibration print ok but it needs some help.
January 25, 2014 01:58PM

Registered: 10 years ago
Posts: 553

ABS or PLA? If it is PLA you might want to try turning your fan up/on.

greghoge.com

HUGE 3D PRINTER PARTS SALE!!!

Reply Quote

Floyd

Re: Calibration print ok but it needs some help.
January 25, 2014 10:36PM

Registered: 10 years ago
Posts: 770

As stated im printing with ABS

Reply Quote

Ohmarinus

Re: Calibration print ok but it needs some help.
January 26, 2014 08:34AM

Admin
Registered: 11 years ago
Posts: 3,096

Insulating the heating block on the hotend solved my hotend issues. I can now succesfully bridge a few centimeters without trouble with ABS and printing high objects works fine, however, when the high objects are very small I still have to print two copies on the sides of the printbed so the print can cool.

Reply Quote

Floyd

Re: Calibration print ok but it needs some help.
January 27, 2014 12:03AM

Registered: 10 years ago
Posts: 770

How did you insulate the block?
I did see a little ABS coming from the heater area so I cleaned it and tightened it back down, Do you think thats all it was? I havent had time to print another calibration print yet.