Print sinking in any help is appreciated February 10, 2019 12:37PM |
Registered: 7 years ago Posts: 7 |
Re: Print sinking in any help is appreciated February 10, 2019 02:06PM |
Registered: 9 years ago Posts: 752 |
Re: Print sinking in any help is appreciated February 10, 2019 02:12PM |
Registered: 11 years ago Posts: 5,780 |
Re: Print sinking in any help is appreciated February 10, 2019 04:09PM |
Registered: 7 years ago Posts: 7 |
Re: Print sinking in any help is appreciated February 13, 2019 04:03PM |
Registered: 5 years ago Posts: 26 |
Re: Print sinking in any help is appreciated February 13, 2019 08:19PM |
Registered: 6 years ago Posts: 1,863 |
Re: Print sinking in any help is appreciated February 14, 2019 11:37AM |
Registered: 7 years ago Posts: 619 |
Quote
nukes88
I searched all the common printing issues and didn't find a solution to this, I recently rebuilt my printer because it was all out of alignment and the frame was kinda wonky. Did 2 prints and both came like this I used cura and only tweaked the temps and slowed the appeal down a little. It is pri twd in and and infill 30% honeycomb.
Any help is appreciated
Thank you in advance