Assembling a 0.3 mm hot end May 30, 2014 02:55PM |
Registered: 10 years ago Posts: 19 |
Re: Assembling a 0.3 mm hot end May 31, 2014 07:12AM |
Registered: 12 years ago Posts: 78 |
Re: Assembling a 0.3 mm hot end May 31, 2014 01:16PM |
Registered: 10 years ago Posts: 19 |
Re: Assembling a 0.3 mm hot end June 06, 2014 11:28AM |
Registered: 12 years ago Posts: 78 |
Re: Assembling a 0.3 mm hot end June 06, 2014 03:22PM |
Registered: 10 years ago Posts: 780 |
Re: Assembling a 0.3 mm hot end June 09, 2014 04:20PM |
Registered: 12 years ago Posts: 78 |
Re: Assembling a 0.3 mm hot end June 10, 2014 07:01AM |
Registered: 10 years ago Posts: 2,472 |
Quote
SallyRepRap
It will produce finer prints, but it doesn't take proportionately longer. This is because the infill can be made relatively coarser and so happens almost as fast as for a coarser nozzle. There is very little impact on strength when doing this.