First layer infill "ripples" March 15, 2015 11:31AM |
Registered: 9 years ago Posts: 18 |
Re: First layer infill "ripples" March 15, 2015 01:22PM |
Registered: 9 years ago Posts: 191 |
Re: First layer infill "ripples" March 15, 2015 02:01PM |
Registered: 10 years ago Posts: 1,230 |
Quote
stuart576
..Now so far I've stuck with plain old Kapton tape on a heated bed and I get fairly good results most the time, provided my first layer speed is pretty slow, as above. I've seen a few videos around where printers wizz around at high speeds, even for the first layer. What's the trick? What's the best method for bed adhesion out there at the moment?
Quote
I'm not talking bed levelling as I think I've got that nailed excepting I think the middle of my glass is slightly bowed, can I do 5-point bed compensation manually (i.e. G30 P0 X60 Y20 Z0..P2...P5)?
Re: First layer infill "ripples" March 15, 2015 02:57PM |
Registered: 9 years ago Posts: 18 |
Re: First layer infill "ripples" March 15, 2015 03:34PM |
Registered: 10 years ago Posts: 1,230 |
Quote
stuart576
I'll give the sanding a go. I take it that the rougher surface increases adhesion?
Quote
I found out about the extra P4 just a few minutes ago, out of curiousity can I add as many points as I want?
Re: First layer infill "ripples" March 15, 2015 04:26PM |
Registered: 9 years ago Posts: 102 |
Re: First layer infill "ripples" March 19, 2015 02:40PM |
Registered: 9 years ago Posts: 18 |