Makerfarm i3v marlin firmware issue February 28, 2016 12:18AM |
Registered: 8 years ago Posts: 4 |
Re: Makerfarm i3v marlin firmware issue February 28, 2016 05:00AM |
Registered: 8 years ago Posts: 269 |
Quote
Pizzman76
I purchased a induction sensor and aluminum heat bed to setup auto bed leveling on my i3v. Once arriving to part where I needed to update my firmware to enable ABL, I noticed it was a old version which didn't have that feature available. After downloading the latest version of marlin firmware from the repository, updating the settings to best match my original settings with only the addition of enabling ABL feature, I ran into one more major issue.
Every time I upload the new firmware, it locks the board up rendering it useless until the original "makerfarm version" is uploaded again.
Has anyone ran into this problem? I attached the config in the hope some could point this newbie programmer in the right direction.
//#define REPRAP_DISCOUNT_SMART_CONTROLLERAnd if you want SD Card support you need to uncomment
//#define SDSUPPORT
Re: Makerfarm i3v marlin firmware issue February 28, 2016 03:46PM |
Registered: 8 years ago Posts: 4 |
Re: Makerfarm i3v marlin firmware issue February 28, 2016 05:11PM |
Registered: 8 years ago Posts: 269 |