M600 or filament change feature activates at the beginning July 10, 2019 11:14AM |
Registered: 4 years ago Posts: 1 |
Re: M600 or filament change feature activates at the beginning August 16, 2019 09:45AM |
Registered: 4 years ago Posts: 1 |
Re: M600 or filament change feature activates at the beginning August 16, 2019 08:49PM |
Registered: 6 years ago Posts: 1,863 |
Quote
baliza
Hi
Did you sent M119 to the printer?
You can see if the sensor is working properly
If the filament sensor appears open, you need to change the FIL_RUNOUT_INVERTING
I hope this was helpful
Baliza