Dremel-Holder

Does anyone have a design of a dremel-holder?
Something with the right meassurements for the
part where you can screw-attach tools to it.

---

-------------------------------------------
* homeprototype free 3d design repository
* Blog
* Google+

ACK

That would be something very handy to have. Making it with conventional tools is very hard if not impossible, so extruding that threaded part is a perfect job for an extruder.

I needed a Dremel clamp to hold my dremel look alike on to Bertha here is what I used :-

Dremel’s chainsaw sharpening kit (#1453) is a fantastic little Dremel attachment to mount your Dremel or Dremel look alike on to your RepRap or CNC macine.

Im sure that some one skiled with any of the 3D packages could construct a simple replacement for the quite expensive part from Dremel The other Clamp is made from a piece of MDF with a Split hole and a 5mm bolt and Stud joining long nut or just a Wing nut.

Its expensive as you dont use any of the other parts in the kit very often if at all. Pic of the clamp in use on Bertha

From

Close up pic of the usefull bit:-

[www.how-to-home.com]

---

Bodge It [reprap.org]
=======================================

---

BIQ Sanguinololu SD LCD board	BIQ Stepcon	BIQ Opto Endstop
BIQ Heater Block PCB	BIQ Extruder Peek clamp replacement	BIQ Huxley Seedling
BIQ Sanguinololu mounting	BIQ standalone Sanguinololu or Ramps mounting	Print It Stick It Cut it

My rep strap: [repstrapbertha.blogspot.com]

Buy the bits from B&Q pipestrap [diyrepstrap.blogspot.com]
How to Build a Darwin without any Rep Rap Parts [repstrapdarwin.blogspot.com]
Web Site [www.takeaway3dtech.com]

Dremel’s chainsaw sharpening kit

Good to know. Thanks Blodge It.