Today I got my printer back up and running again after a failure of the x endstop that caused some major damage to the extruder. First thing I did was plug it back in to repetier host on my mac, which is the laptop I have been using to run the printer for the past three years, and tried to connect. I was presented with a "Could not open port for usb device" error which is something that never hapby bnoggle - Reprappers
I am running repetier host mac, and have been for almost 3 years without any problem. All of a sudden when I start it it only connects some of the time. I checked my baud rate and it appears to be fine. I recently migrated to a new computer, but it was working fine at the beginning and now it is not. The prints will start, run for a few short seconds and then stop. I have already tried deleting tby bnoggle - Repetier
I am trying to find the best place to purchase 1.75mm PLA filament. Currently i purchase filament from eshop2018.com with mixed success. Any suggestions would be appreciated.by bnoggle - General