Along with 4 stepper drivers, I've also managed to completely fry my nichrome wire that connects my m6 heatcore to my RAMPS. Now because I've ordered this hot end kit from overseas (I'm in aus) it's difficult to get an exact replacement so I've gone and bought some uninsulated nichrome wire (was the only available). Is there anything important I'm missing here? Should I cut approximately the sameby T-Carbs - Controllers
Hi I've recently started trying to upload my software onto my reprap etc.. Before doing this I used the RAMPS 1.4 test code. At first both my extruder and z axis worked properly (up and down) however my X and Y just seemed to vibrate. I've adjusted the pots and all this seemed to do was to make the vibrating more/less violent. I've since switched the drivers around to test whether it wad the aby T-Carbs - Stepper Motors, Servo Motors, DC Motors
JoeDaStudd I took everything off, tried the code and put the stepper motors back on one by one, the all appear to be working so i haven't fried anything (i hope) Now just to upload the firmware and get things working again Thanks Tomby T-Carbs - RAMPS Electronics
Okay I'm having some strange problems with running my electronics. I'm running the Ultimachine.com ramps 1.4 and it doesn't seem to be connecting properly. I've managed to upload sprinter onto my arduino (i think) however i come across this strange issue when I connect my Ramps to my arduino (by stacking them on top of eachother), my computer no longer recognizes it. So when it is just the arduinby T-Carbs - RAMPS Electronics