I would like to be able to re model the printed parts in inventor without having to measure off of already printed parts, and am having trouble finding schematics or just dimensions? any one know where I could find that? edit: this if for the prusa I3by Hypnofrogs - General Mendel Topics
thanks a lot! got it all working! Printing off a cable chain I designed right now!by Hypnofrogs - Firmware - mainstream and related support
I'm getting a weird error and I cant find the cause, I have also tried searching and havent found a solution. Im using the current stable version (previous version) of arduino A ramps board I believe 1.4 and I believe the newest version of marlin, I'm receiving this error. I switched over to Sprinter and its all working now, but whenever i print something it pops up with an error and canby Hypnofrogs - Firmware - mainstream and related support
M502 returns nothing but a, "Yes". I have started editing marlin directly but I am now getting weird errors while trying to compile.by Hypnofrogs - Printing
My E is set and works fine but my X Y and Z seem to reset themselves when i change and save them into the repetierhost EEPROM editor, whats going on with this? its supper frustrating to get the printer calibrated to a decent degree to print and it starts doing that again. I'm scared to actually load marlin from arduino onto my board with the settings because there looks to be a lot of settingsby Hypnofrogs - Printing
I have been looking around the web for a solid well known step by step to calibrate the Prusa I3 and have yet to find it, Does anyone know where that might be? mostly looking for a guide on how to setup my Z height because nothing round that is printed along the Z axis is coming out round.by Hypnofrogs - General
It is the MK2B dual power heat bed I believe it was wired properly, I followed direction in this video heat bed at around 12:48. The soldered wires were done flawlessly. it didnt look scratched or marked, but yes had a slight curve as it should. And there was nothing under my bed and the table. I suppose I will e-mail the company i got it from and see if they will do anything about it,by Hypnofrogs - Safety & Best Practices
So this is a problem and safety concern, at this point my heated bed is not usable and I think is now garbage. I built the prusa I3 this week and finally got it printing and working, not calibrated but oh well. The heated bed only works on half the bed most of the time and sometimes will work on both or the other half of the bed. I turned the bed up to 70C and it started to smoke, I looked undeby Hypnofrogs - Safety & Best Practices