Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
Hi ,
I have been having the moire effect and have been trying to ground the R4 resistor by dropping a blob of solder on to it, for some reason my drive stops working after that, I have attached an image of my board with the 3d printed part with the moire effect. I am not sure as to which part needs to be soldered, or If I am actually soldering the correct resistor, or damaging the board while so
by
hussainsail2002
-
General
Hi all,
I have built a 300 X 300 X 300 machine,
I am currently having an issue where the lead screws are unable to lift the bed up.
I am using two 8 mm lead screws and have increased the current as well.
I would like to know if decreasing the default max speed value in marlin will provide more torque to the motors for lifting the bed. ??
For homing moves moves what values of speed are taken
by
hussainsail2002
-
Firmware - Marlin
Hi All,
I have been using a filament run out sensor for a while and it has been useful.
When I print with flexible filament though I would like to disable it and send the filament directly to the hot end.
Marlin 2.0 has the M code M412 S1/S0 to enable or disable the filament run out sensor. I tried adding it to the start g Code but to no avail.
The filament sensor still triggers.
Any sugges
by
hussainsail2002
-
Firmware - Marlin
I recently tried printing a part on slic3r that had internal threads. The part has printed without the threads.
The mating part with external threads has printed fine. Am I missing something in the settings ?
I have a 0.4 mm nozzle on a wanhoa i3
Thanks !
by
hussainsail2002
-
Slic3r
I am new to the forum
I dint know where to post this, but wanted some help
the potentiometer on my printrboard has worn out and now am not able to adjust the current to my x motor.
what is the best way to change
thanks in advance!
Admin Edit : split topic and changed title.
by
hussainsail2002
-
Controllers