Show all posts by user
Page 7 of 7
Pages: 34567
Results 181 — 188 of 188
Hi-
I just completed my Prusa... this morning. I got two test prints then had to go to school.
Printing started. Far too much plastic was being extruded. My extrusion was at .1 when i finally had a nice print... But it was about 1/8 as tall as it was supposed to be (ish). So I know my z axis isn't moving enough. How do I fix this.
RAMPS 1.4. Prusa Mendel. .35mm nozzle. 1.75mm filament. Pronter
by
N314
-
General
Ok...
I switched to Marlin firmware and things are working better. They are still a bit sketchy, but I think I can make it work.
Thanks for all the help,
-Nick
by
N314
-
General
How do I change the Firmware?
by
N314
-
General
Now weird things are happening.
I connected all motors. Endstop on X. Powered up. Clicked move on X and the extruder motor started moving. Also No other motors will work.
What am I supposed to do... I'm so confused.
-Nick
by
N314
-
General
I connected everything, then powered up. I had an endstop on X. I did a test print and nothing. With a voltmeter ive found theres voltage (but no action) on X and Extruder... No voltage on Y and Z.
What can I do?
-Nick
by
N314
-
General
1. X axis and Extruder do.
2. Is there a certain way to. I have tried both ways.
3. I experimented with the X pot to no avail.
-Nick
by
N314
-
General
Hi-
I plugged in my electronics and tried to get a motor to move. When I plug the motor into X and E0, they make a slight hum... tell it to move, nothing happens. I plug it into Y and Z... No sound or movement. How do i make them work?
RAMPS 1.4, Pronterface
-Nick
by
N314
-
General
Page 7 of 7
Pages: 34567