To upload firmware use Arduino 1 instead of Arduino 1.0.5by gm_chandru - Reprappers
i have used adrino 1 insted of adrino1.5 and issue solvedby gm_chandru - Reprappers
already I have downloaded and installed the U8glib to ARDUINO library folder but still i am getting errorby gm_chandru - Reprappers
Hi try to coonect full graphics LCD to my reprap but i am getting below error please help me LCD is ON when connected laptop and not displaying any info if i removed USB from laptop LCD will be off. PFA error message which i am getting while updating firmwire i am using Marlin ---------------------------------------------------------Error message----------------------------------------------by gm_chandru - Reprappers
Hello, I have built my Prusa I3 and today i was doing some Calibration Cube print testing. after some time hotend stopped extruding i have increased the temperature and did all .trial and error. But No result. what is the process to clean HotEnd when it jammed? Regards, Chandruby gm_chandru - Reprappers
Thank You Uncle Bob 1. Have changed the wiring and did the changes in Marlin firmware. changed true to false it started working. // The pullups are needed if you directly connect a mechanical endswitch between the signal and ground pins. const bool X_ENDSTOPS_INVERTING = true; // set to true to invert the logic of the endstops. -----------------------------! const bool Y_ENDSTOPS_INVERTING = tby gm_chandru - Reprappers
Hello, I am building Pruisa I3. all the calibration done. but i am facing below issues to complete the build and start printing 1. End Stops not working. when i move to home position it is hitting to End stops and moving further motor will not stop. wiring and all fine. if edit the firmware (using Marlin) // #define ENDSTOPPULLUPS // Comment this out (using // at the start of the line) tby gm_chandru - Reprappers
I am using power supply intended for use in a PC, a multi output ATX supply.by gm_chandru - Reprappers
Hello I have built the Prusa i3 and have Issue with End stops. motor movement will not stop after hiting the End stops. all the 3 axis same issue. Please help me. Regards, Chandruby gm_chandru - RAMPS Electronics
Hello, I am facing same problam. have 450W SMPS, can you please explain how can i solve this issue with images if posible. Regards, Chandru.by gm_chandru - Reprappers
Hello, which is Prusa i3 Microstepping Is it 1/8 or 1/16 or 1/32 WIll it effect the Output Quality? Regards, Chandruby gm_chandru - General
Hi Karan Please let me know from where can i buy this 3D printer i am in Bangalore. Regards, Chandru.by gm_chandru - India RUG