QuoteRoxy I think we could be a little more elegant about it. Ignoring the SD-Memory card case, we could have the host computer keep track of how far it got. And it could do some clever things to recover and start from where it left off. Probably, it would have to do things like re-align the nozzle and purge some filament. Is there any software exist for this aim? Best Regardsby yuzmemak - Firmware - Marlin
Hi Isn't it good idea?by yuzmemak - Firmware - Marlin
Hi, Any experience for logging to recover failed print? If we log what all gcode steps with error codes, we would recover our half printed items. Best Regardsby yuzmemak - Firmware - Marlin
Hi, Until today I was using my old computer for powering my reprap. Than I decided to stop using a computer because I have allready smart graphic controller. I bought 9V 2A AC to DC converter and plug in to japan jack. Only very week red light illimunate on the mega 2560 board and no light up on the smart screen. After googling I could not find any god answer, why? Welcome any idea for poweriby yuzmemak - Prusa i3 and variants
Quoteo_lampe Did you inspect the thermistor socket on the controller for intermittent shortcuts? Hi, I have MINTEMP error and no clue until now for troubleshooting. How can I inspect socket for intermittent shortcuts? Best Regardsby yuzmemak - Reprappers
Hi, I checked thermistor with omhs meter and it gives me around 100K for heatedbed as expected. Any troubleshooting guide for ramps or mega 2560? Could be board problem? Best Regardsby yuzmemak - Reprappers
Hi, My min temp settings are like these; #define HEATER_0_MINTEMP 5 #define BED_MINTEMP 5 But I am reading 0 (zero) less than min temp settings which are 5.by yuzmemak - Reprappers
Hi, How can I check connection? Do you mean physical connection to ramp4? Best REgarsby yuzmemak - Reprappers
Hi, My printer was working for 9 months. Today it is stopped with Err: MINTEMP. Right now Extruder and Heated bed temparature are reading zero. If one of them shows zero I can do my troubleshoot for that part of the printer. But when both shows zero, where can I start my trouble shoot and what would be steps? Here is min temp settings; #define HEATER_0_MINTEMP 5 #define BED_MINTEMP 5 Any helpby yuzmemak - Reprappers
Hi, Very strange no body answered! I suspect to change solid infil area to 0. Could be solution? Best Regardsby yuzmemak - Slic3r
Hi, you can see my milenium print as follows. Everything is very good except front side of the ship. I think, if print only outside, it will be no problem. When filling inside, pla become more than neccessary. Which setting, I need to correct? Best Regardsby yuzmemak - Slic3r
Hi, I find my self after changing x and y 4 pin sockets. Socket was not attached well. Thanks any way.by yuzmemak - Prusa i3 and variants
Hi, I just finish building my reprap prusa i3. All axes are good except Y. When I try to control manual, it moves both direction even I click only one direction. - I give 50mm forward command, it works good - but after givin another 50mm forward command, it goes back instead of forward. Any idea?by yuzmemak - Prusa i3 and variants