reminds me of the black belt 3d Printer. Although you can change from vertical to angled to the bed with yours. And your bead is heated? Great job.by Gearsawe - Look what I made!
And and here I am doing the opposite. Belts for everything including the Z axis. Backlash nuts only work up to a certain speed then momentum will compress when stopping quickly or changing direction.by Gearsawe - Reprappers
I'm going to or hope to use these 50W heater cores for my extruders which are meant for 24V, and yes I am building 24V system. So this works out to about 2.1A each. I am looking are the MOSFET for the extruders. The numbers on them are 7R060 I could not find the exact specs but this is the closest I found is... PSMN7R0-60YS If I am reading this right at 100C these are rated for 63A (Page 3) anby Gearsawe - Controllers
The Short Answer is no. If at room temp it measures close to 10K omh then you do have a 10K Omh. if it does measure close to 100K at room temp then there is something else wrong.by Gearsawe - Reprappers
MK4Duo has the features I need for the Rumba board I am using. Running into a problem where the 2 heaters I have Enabled and 1 one Cooler will not turn on. The board has indicator LEDs so I tried to Invert the logic in the firmware and they light up but setting their target will not turn them off. Or will not turn on with the logic set normal and set the target. So ruled out pins not correct. Theby Gearsawe - Reprappers
Can some one test if thermal runaway is working in bugfix1.1.x? Right now I do not have much connected to my controller basically only Themister and LCD with Encoder and SDCard. I set the temp to 1. It is reading the room temp at 23. I would think after a short time I should get a thermal runaway error. I do get a Heating failed when I set the temp 50 and the temp is 23 in the room. Thermal Proteby Gearsawe - Firmware - Marlin