Hello, I just try to progamm my new skr pro 1.1 with 2130 spi v3.0 I would like to use them to do sensorless_homing and probing. So I defined drivers for X, Y, Z (TMC2130) and uncomment #define SENSORLESS_PROBING When I compile : I've got this error : #error "SENSORLESS_PROBING requires a TMC stepper driver with StallGuard on Z." If I comment the #define sensorless_probing, compilation isby davidmarli - Firmware - Marlin
Hi, I just bought a ramps 1.6. It seems great, but when I plug my bltouch in servo, nothing lights on... With my multimeter, there is no 12v between + and - but 0v... So is there something to do to have power on servos ? I see 2 pins with no connectors J4 (betwwen the two green connector) is that the solution ? I find nothing about this ramps 1.6 Thank a lot.by davidmarli - RAMPS Electronics
Du coup ce matin j'ai essayé en refaisant ma pièce. Je veux un carré de 40x40 avec un trou circulaire de diamètre réel 23,25mm et deux trous rectangulaires de côtés réels 2,3 et 23,25mm J'ai fait d'un cercle de diamètre 23,25+0.4 (diam de ma buse) et deux rectangles de côtés 2,7 et 27,25mm Résultat à l'impression les trous sont parfaits : 23,25mm de diamètre et rectangles de 2,3x23,25 !!! Lby davidmarli - RepRap Groupe d'Utilisateurs Francophone
Ok, donc c'est à moi de faire mon propre fichier en tenant compte de la largeur de la buse. J'essayerai cela. Merci.by davidmarli - RepRap Groupe d'Utilisateurs Francophone
Ok. But If I want later such a hole in a frame, I want it to have the accurate size ... So what's the solution for my pb ? Thank youby davidmarli - Printing
Hi, I have a pb with my Itopie. It prints well, but it's not accurate. I tried to print this object : The printed square is 40.05 x 40.06 mm : it's perfect for me. BUT the circle mesure 22,6 mm instead of 23.25 mm !!!!! Today I try to modify the X and Y settings in configuration.h (in marlin). So I change my 80 values for both axes in 82.3. Now the circle is perfect (23.26 mm) but the sby davidmarli - Printing
Bonjour, j'ai monté mon itopie, tout fonctionne bien, mais j'ai un pb de calibrage : J'ai imprimé cette pièce : Le carré imprimé mesure (avec mon pied à coulisse) : 40,05 mm sur les deux axes (X et Y) donc pour moi c'est parfait. Le cercle au milieu est censé faire 23,25mm de diamètre, mais moi il ne fait que 22,6 mm. Donc comment se fait-il que les mesures des côtés du carré soient bonnby davidmarli - RepRap Groupe d'Utilisateurs Francophone
Hi, I buy the same kit : ramps 1.4 + RepRapdiscount full graphic display, and after televersing marlin, the screen lights up but nothing appear on it. It try a 220 and 440 between pin 2 and 3, but nothing change. What Am I doing wrong ? Thanksby davidmarli - Controllers