Welcome! Log In Create A New Profile

Fire Cement

Posted by lcomtois

Forum List Message List New Topic

lcomtois

Fire Cement
September 16, 2009 09:41AM

Registered: 15 years ago
Posts: 31

Why is fire cement needed over the insulated nichrome wire in the ThermoplastExtruder 2.0 design ?

Reply Quote

nophead

Re: Fire Cement
September 16, 2009 09:56AM

Admin
Registered: 18 years ago
Posts: 7,881

You need something to keep the wire in place that will stand the heat. Nichrome expands when it gets hot, so it will not stay tight.

Makerbot use Kapton tape instead.

[www.hydraraptor.blogspot.com]

Reply Quote

BodgeIt

Re: Fire Cement
September 18, 2009 07:57PM

Registered: 16 years ago
Posts: 478

You can get Kapton tape from www.dealextream.com at Price: $2.92 with free shipping

link to 10mm tape 300c [www.dealextreme.com]

Edited 1 time(s). Last edit at 09/18/2009 08:10PM by BodgeIt.

Bodge It [reprap.org]
=======================================

BIQ Sanguinololu SD LCD board	BIQ Stepcon	BIQ Opto Endstop
BIQ Heater Block PCB	BIQ Extruder Peek clamp replacement	BIQ Huxley Seedling
BIQ Sanguinololu mounting	BIQ standalone Sanguinololu or Ramps mounting	Print It Stick It Cut it

My rep strap: [repstrapbertha.blogspot.com]

Buy the bits from B&Q pipestrap [diyrepstrap.blogspot.com]
How to Build a Darwin without any Rep Rap Parts [repstrapdarwin.blogspot.com]
Web Site [www.takeaway3dtech.com]