Hi,
I think the attached video show an extruder jam ?
[
www.youtube.com]
The stepper motor started ticking over during a print, and I tried to start print again which is on the video (and quickly turned it off).
I have just purchased the machine and is starting to learn about 3D printing, but the only thing I know is that it is a MendelMax1.5, but is not enough to do a detailed search on the extruder.
I use 3mm PLA, that is from the end of a roll, so it is very curved.
Should I increase extrusion temperature, currently at 185 degrees ?
I have made a successful print: