had the libs but I was using 1.0.3 ,, just tried compiling with 023 and went fine ,, haven't loaded it to board yet,, but i'll let you know how it went.by cwalker1960 - General
pfinucan Wrote: ------------------------------------------------------- > Hey, > > Anyone know where to get eggbot firm ware for the > arduino uno that works? I have the mechanical > stuff all working but can't get a firmware to > compile in the arduino software. > > I can't get this software to work. > > > I tried the arduino 1.0, 1.01, and 0023. I chasedby cwalker1960 - General
it's a makerbot clone with the exception of the drive gear. bought 2 during kickstarter.. messed with it for days and like everyone is saying the gear just shreds the filament. the only mod i made was buying a new makerbot style gear from an ebay source ($12.00 USD +$4.00 shipping ) and it's been working great every since,, PLA and ABS.. I would buy another if I needed an extruder and I'd buy thby cwalker1960 - General
fsamir Wrote: ------------------------------------------------------- > Hi everyone, > > this part is a thick idler for a Makergear Prusa > and it is 11mm tall, but the printing is coming up > with 13.22mm. > Also, the hole is actually a oval instead of a > perfect circle. > > I thought that the oval effect was caused due to > low tension on the X and Y belts, butby cwalker1960 - Printing
dean448 Wrote: ------------------------------------------------------- > First off I'm printing PLA at 170. I was > printing on a cold bed with double sided carpet > table. The goal was to get maximum bond to the > surface to reduce warping on long parts. It > kind of worked but I could see deformation on the > first 5 layers of the edge against the bed. > > So Iby cwalker1960 - Printing
Worked great,had given the same idea some thought already but the coding eludes me until I see it , then it all makes sense, Thanks Andyby cwalker1960 - RAMPS Electronics
foshon, Do you bother reading before you write?? I said I set all the configurations according to his wiki page,, and it still didn't work.. well no thanks to anyone on this site I figured out how to check things out for myself and what I found was pin 25 on the ramps board was shorted to ground.. Not something that I missed in configuration and not something that most people just wanting to buby cwalker1960 - Reprappers
I bought the complete electronics package from reprapdiscount. It has the arduino mega board, ramps 1.4, 5 stepper drivers, and smart controller with lcd screen. I haven't completed my reprap yet but I have attached all the motors to the drivers, limit switches, thermisters for hot end and bed. Loaded marlin and set all configurations, commented all lines as suggested on reprapdiscounts wiki. Inby cwalker1960 - Reprappers