Sorry, I actually had it as M563 P0 D0 H1.. but you mean I should just take out that line and should work? I've attached the g code if that helps at all.by hmcclint - Printing
I changed the steps per mm to 70 and have the line M563 P0 D1 G10 P0 S-273 R-273 X19 Did I mess up with where I put the zeros? Does it have to be both P0 an D0? I also sent the M302 command and that worked, so I know it's set to cold extrudeby hmcclint - Printing
Here's what I have for the paste extruder: I have a file that's config.g that seems to have all the parameters, where would I find configuration.h?by hmcclint - General
It's 1.09. I just started commissioning the printer so it's the newest one on GitHub.by hmcclint - General
I send T0 to select the motor (I only have 1 extruder hooked up) and then M302 P1 to set the extruder to cool (I don't need the hot end). I know T0 must be correct because when I manually send a command for the extruder to extrude (without the nozzle moving aroung), the motor works fine.by hmcclint - Ormerod
Hi! I have an Ormerod 2 and have it set to extrude using a paste extruder instead of the ABS/PLA. When I manually extrude using Pronterface, the motor works fine, but when I send a print from the SD card, the nozzle moves as if it's printing, but the extruder motor doesn't turn. Do you have any suggestions? It's connected by USB as well as to a power supply so I think it should be getting enoughby hmcclint - Stepper Motors, Servo Motors, DC Motors
Hi! I have an Ormerod 2 and have it set to extrude using a paste extruder instead of the ABS/PLA. When I manually extrude using Pronterface, the motor works fine, but when I send a print from the SD card, the nozzle moves as if it's printing, but the extruder motor doesn't turn. Do you have any suggestions? It's connected by USB as well as to a power supply so I think it should be getting enoughby hmcclint - Ormerod
Hi! I have an Ormerod 2 and have it set to extrude using a paste extruder instead of the ABS/PLA. When I manually extrude using Pronterface, the motor works fine, but when I send a print from the SD card, the nozzle moves as if it's printing, but the extruder motor doesn't turn. Do you have any suggestions? It's connected by USB as well as to a power supply so I think it should be getting enoughby hmcclint - General
Hi! I have an Ormerod 2 and have it set to extrude using a paste extruder instead of the ABS/PLA. When I manually extrude using Pronterface, the motor works fine, but when I send a print from the SD card, the nozzle moves as if it's printing, but the extruder motor doesn't turn. Do you have any suggestions? It's connected by USB as well as to a power supply so I think it should be getting enoughby hmcclint - Printing
Hi! I have an Ormerod 2 and have it set to extrude using a paste extruder instead of the ABS/PLA. When I manually extrude using Pronterface, the motor works fine, but when I send a print from the SD card, the nozzle moves as if it's printing, but the extruder motor doesn't turn. Do you have any suggestions? It's connected by USB as well as to a power supply so I think it should be getting enoughby hmcclint - Reprappers