Tried it, don't workby Sanjaykray - Printing
I'm using self made prusa type printer (with marlin, slic3r) the prints are just great ,but a strange problem,before starting to print from my sd card (which I always do) I've to manually heat the bed and nozzle from my lcd controller.I have tried cura it makes the heatbed working but not the hotend Please someone help.by Sanjaykray - Printing
Worth trying.by Sanjaykray - Safety & Best Practices
Very good idea . In fact the best idea by which you won't loose the pot trimming option.by Sanjaykray - Safety & Best Practices
A4988 and DRV8825 heat sink mod ,The surface area of the chip is actually lot less than the heat sink available in the market,You have to be very careful while installing coz it is very much possible that it will touch the surface mounted parts or the legs of the drivers.I myself lost few drivers when the heatsink got in touch with the pins and phew ! Magic smoke ,So I found a way just using a fiby Sanjaykray - Safety & Best Practices
Resolved !!! Just changed the stepper driver and everything is fine now (X axis). Thanks everyone for your helpful suggestions.by Sanjaykray - Printing
I'll try that,thanks Tinchusby Sanjaykray - Printing
Thanks for the pointer James.by Sanjaykray - Printing
I've adjusted the pots on stepper drivers,lubricated the rods and belts are also quite ok .Very confused may be someone help??by Sanjaykray - Printing
I am using my scratch built paisa i3 (ramps1.4+mega-latest marlin) while trying to print my first print the problem is that every next layer of print gets printed on totally new place (x axis) attached is the result of 2cm cube .I am using slic3r.Please help guys.by Sanjaykray - Printing
connect it to the outermost side If you put wrongly on the voltage pin that will be an instant death for mega ,I did onceby Sanjaykray - General Mendel Topics
I was using mega on ramps and after a while i noticed the mega's 5voltage regulator beside the 12volt barrel connector was too hot to touch and everything stopped I am using 12 volt -20amp power supply,later i replaced the regulator on mega and connected to pc no heating is observed but I am not able to upload anything on arduino mega. 1) Is the 20Amps the reason for it ? 2) Should i remove the Dby Sanjaykray - Controllers
Thanks , one more thing I fried my mega while connecting end stops I bought a new mega but now my extruder 0 isn't working I want to use the second extruder on ramps ,can you please tell what changes do I have to make on marlin ?by Sanjaykray - Firmware - Marlin
Do I have to change anything on marlin if i use DVR 8825 AND A4988 together on ramps 1.4 boardby Sanjaykray - Firmware - Marlin
Can anyone share the pdf doc. from rcjoseb (though it's an old youtube video) I tried the link of the blog but it doesn't seems to be working ,by Sanjaykray - Smart_Rap