Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 10 of 10
I have a 3d printer with e3d chimera 2 in 2 and two extruder.I have a problem about extruder when i print my 3d printer.printer not change tool also wait and stop it is not love
What is the tool change script
by
malio77
-
Printing
i have a 3d printer but when i heated hotend and printed 3d parts while hotend reach 220 degree i take a error thats mean heating failed killed what is reason that error
by
malio77
-
Prusa i3 and variants
I have a e3d chimera v6 dual extruder single nozzle hotend.i want to make dual extrusion for multicolor printing.i a m using simplify3d what should be starting script also which can i make setup in the marlin firmware.i m wait for comment and advise.
by
malio77
-
Mechanics
I have my drv8825 motor drive, and I have a problem with it. I installed the motor driver on the ramps card, but when the 3d printer starts to print, it prints the track a bit smaller than normal and starts at any point on the table, not the origin.What is that solution
by
malio77
-
Prusa i3 and variants
How can i print multicolor printing one single extruder.
by
malio77
-
Printing
Heatbed moves smoothly it doesnt moves to diffucult
The 3d printer's y-axis strap was very tight I loosened the y-axis strap a little but it has got a layer shifting on which my pressed parts.
Could it be because your head moves too fast because head moves very fast ,could i change printing speed.
by
malio77
-
Prusa i3 and variants
It is maybe wrong sensor value on marlin.ini
Check your sensor on the heatbed its must be bonded heatbed
by
malio77
-
RAMPS Electronics
Why is the my 3d printer layer shifting on the y axis when printing parts.
by
malio77
-
Prusa i3 and variants
Hello i am new user this forum and i have a problem with my 3d Printer. As soon as i open the 3d printer, the heatbed starts to warm up also it doesnt stop. I do not do anything about the temperature.Heatbed warm up to 90°.what has it got a problem my 3d Printer please help me. Does this create problems from 3d Printer now thank for your comment
by
malio77
-
General