Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
How to use controller fan on skr 1.4
by
barisali77
-
Printing
I have a 3d printer with skr v1.4, but when I turn on the machine, I get maxtemp error at startup, the same problem does not occur when I unplug the thermistor cable, how can I solve this problem?
by
barisali77
-
Printing
I bought a ntc thermistor and soldered it, but the thermistor shows the wrong value, I wonder where the error, can i change the marlin to t0 pin t2
Value is always 52 °C
by
barisali77
-
RAMPS Electronics
I bought a ntc thermistor and soldered it, but the thermistor shows the wrong value, I wonder where the error, can i change the marlin to t0 pin t2
Value is always 52 °C
by
barisali77
-
Prusa i3 and variants
Thanks for your advice i had measured from under extruder
by
barisali77
-
Mechanics
I have a mk8 extruder i m using as bowden .i have a problem about extruder calibration when i extrude 10mm from pronterface i give result from 10 mm too long like overextruding.i didnt solve this problem.what is the cause of problem is this maybe from mk8 extruder.pls help me
by
barisali77
-
Mechanics
İ have bought a mk8 extruder from china how can i setup mk8 steps per mm settings from marlin 1.1.8
by
barisali77
-
Firmware - Marlin