Show all posts by user
Safety...
Page 5 of 5
Pages: 12345
Results 121 — 125 of 125
Think I have same i3 as you Korri. First power on today
I have end stops
X right side
Y rear
Z bottom down
Managed to get action using Auto Home from LED panel menu
Step by step I got it fine to X and Y end stop
But after that it started movin Z upwards .....
So I'm not sure now i Z end stop shall be up or down.
Or if I have Z motors wired to go wrong direction ...
Having a hard time just t
by
sidhabo
-
Reprappers
Just did first power on of my Prusa i3 printer
Nothing burning
Is there a user manual for how to use the LED thingie knob
Just tried and errored it a bit
I managed to get moving from Auto home function
Got to X and Y end stop fine, small steps each time I push button, but after that it started going upwards in Z
I have my end stop for Z at bottom .... is that wrong or is Z motors not goo
by
sidhabo
-
RAMPS Electronics
Sorted it with Google
Link for anyone else need it
by
sidhabo
-
Reprappers
I have no info in my manuall on how to connect the 2 flat cables from LED panel to RAMP contacts.
50% risk to go wrong there ....
Anyone know ?
Thanks
by
sidhabo
-
Reprappers
Just about to fire up my Prusa today for the first time
Can't seem to find a link for manual to startup calibration ....
Thanks
by
sidhabo
-
General Mendel Topics
Page 5 of 5
Pages: 12345