you seem to be missing a m109 instruction that tells it to wait for extruder to reach temp eg. ;Generated with Cura_SteamEngine 15.01 ; Default start code G28 ; Home extruder G1 Z15 F100 M107 ; Turn off fan G90 ; Absolute positioning M82 ; Extruder in absolute mode M190 S50 ; Activate all used extruder M104 T0 S200 G92 E0 ; Reset extruder position ; Wait for all used extruders to reach temperatby obewan - Printing
might be dissabled in configuration.h //#define SDSUPPORT // Enable SD Card Support in Hardware Consoleby obewan - Prusa i3 and variants
when you start 'printing' the firmware will 1st heat the hot end to the required temperature,it will not move the axis untill the hotend has stabalised for about 10 seconds. Is the hot end reaching the print temperature ?by obewan - Printing
What positions do you have your end stop switches ? In your config.h you have them set for x,y,z - max " 383.// @section homing 384. 385.// Specify here all the endstop connectors that are connected to any endstop or probe. 386.// Almost all printers will be using one per axis. Probes will use one or more of the 387.// extra connectors. Leave undefined any used for non-endstop and non-by obewan - Reprappers
sounds allmost like the x endstop is triggered (apart from the error). does x move if you manually press the x endstop ?by obewan - Reprappers
could be too much contrast , try adjusting the preset on the display pcbby obewan - Reprappers
would the G10 and G11 commands do what you needby obewan - Reprappers
you need to download the u8glib folder and save to the arduino library folderby obewan - Reprappers