you would be wasting your money on Geeetech made board i would go with any other brand over geeetech.by Trix - General
What about using CPAP filters they are cheap, and according to this site they filter out viruses and they can be smaller than 0.1 micron.by Trix - Safety & Best Practices
So, I was working on my extruder when i look at my hot end temp and it was reading 280c and climbing when it was set to 210c . So i shut off the power disconnect the heater and temp prob turn it back and now i can not connect via web and it is not pulling a IP. I can connect using USB i have flash it with the new DC42 firmware and updated the SD card and Pronterface kind of works . Still cant cby Trix - Controllers
So glad i found this post i just ran it to this vary problem but i upload a Macro file and that is what caused it . Removing the cookie did solved it, I am running web interface 1.06 and firmware 1.09k.by Trix - Firmware - mainstream and related support
Sweet, I am so going to have to try them out and see how well my modified folger tech kossel 2020 does.by Trix - Reprappers
I was having the same problem and i figured out was friction between the magnets and ball bearings making the pop off i just put some oil on the magnets and it fixed the problem.by Trix - Delta Machines
Yes i am in the US on the west coast, shipping was 30$ and i got it in 1 1/2 weeks.don't have the two boards as they ask me to ship them back at there expense and have not received my replacement board yet so i don't have any pictures of the whole board, not thier fault i ask the if they could get somethings for me and just ship everything at once. They have great customer service, they have doneby Trix - Controllers
Aye, I sent them a email with pictures. Im sure i won't hear back till Monday and yes thier Q&A needs some work. So far they have had good custumer service, but 2 boards in row and 4 weeks later and still dont have a working board.... Oh, thank you for the help dc it is much appreciated!by Trix - Controllers
Quotedc42 If the red light next to the USB port is on, that means 5V power is getting to the board from the USB project e endstop lights should illuminate when the endstop switches are closed. For normally-closed endstop switches (which is the norm for repraps, and is recommended), this is when they are NOT triggered. Check that you have the endstop switch connectors wired correctly. On the Duby Trix - Controllers
Hi, So i got my first duet board 3 weeks ago and the usb port broke off first time i plugged in the cable so emailed Replikeo and the sent me a replacement which i got today. Now my problem is when i plug the usb in i get the red light on the board next to the usb but my PC does not detect the board nor does it show up in device manager and the end stops do not light up when triggered. I have triby Trix - Controllers