Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 12 of 12
vegetable oil/peanut oil or similar helps a lot on a bowden tube......Don't go too crazy with the oil, or your prints will smell like french frys...
by
Hiram
-
Reprappers
You can also use
M140 S
by
Hiram
-
Ormerod
Looks like a great design.
I just bought a pair of E3d hot ends, for the reason of a wide selection of orifices, and easy Bowden set-up, what would put the setup over-the-top would be a single sink that held both hotend's.
by
Hiram
-
General
strings are usually caused by too much heat and /or not enough retraction.
by
Hiram
-
Repetier
Is there a way rename the Extruder 1 button to Extruder 0 and Extruder 2 to Extruder 1 ??
Thanks
by
Hiram
-
Repetier
I bought 2 e3d bowden hot ends, no set up problems, they were both the exact same height, they work great.
I wired them together at the bottom and top with #14 solid copper wire through the fins...
I am surprised that I did not have any height issues........
by
Hiram
-
General
Nice looking printer.
JB Weld is a good epoxy that can handle a lot of heat.
If you set up for Nylon printing, you wont need a heated bed, Nylon is a little bit cheaper than PLA and ABS, plus it can be dyed with cheap off the shelf dyes.........Nylon is is the toughest printable plastic out there for now...
by
Hiram
-
General Mendel Topics
// Number of servos
//
// If you select a configuration below, this will receive a default value and does not need to be set manually
// set it manually if you have more servos than extruders and wish to manually control some
// leaving it undefined or defining as 0 will disable the servo subsystem
// If unsure, leave commented / disabled
//
#define NUM_SERVOS 1 // Servo index starts with 0 for M
by
Hiram
-
Mendel90
I was looking at the Analog pins and extension header, , and the Ardunio Mega pins 89-94 don't seem to be going to the correct analog pin header as per schematic
all but pin 90 seem to be incorrect.
89 PK0 ( ADC8/PCINT16 ) Analog pin 8 Analog-Ext 1
90 PF7 ( ADC7/PCINT15 ) Analog pin 7 Thermistor 3, Analog-Ext 2
91 PF6 ( ADC6/PCINT14 ) Analog pin 6 Analog-Ext 3
92 PF5 ( ADC5/TMS )
by
Hiram
-
General
Is there any way not to generate skirt while having ooze prevention enabeled ?
by
Hiram
-
Slic3r
Is there a way to turn off the perimiter that Slice3r makes for a multi-material file?
The perimiter does nothing but get in the way, it is too thin and gets broken.........
by
Hiram
-
Slic3r
I am also fighting with my dual extruder upgrade, I am starting to wonder if it was really an upgrade afterall.
Slice3r and Repetier host seem to do whatever they want........
I am trying to print a circle with extruder 2 only, but extuder keeps wantin to print a perimiter.
Extruder temperature 2 also wants to run cooler than 1.........
Good thing I am still somewhat young..
by
Hiram
-
Slic3r