Why not use this TL-WR802N 300Mbps Wireless N Nano Router set up in client mode, then use a DC-DC Buck Converter 6V-24V 12V/24V To 5V 3A USB Output Module to power it . works great for me.by nique911 - Duet
Had the same type of problem would shift at different places, I replaced drivers, motors and ramps. what it turned out to be was Sic3er. I found this out by printing a piece that I had slice a while ago it printed out fine. then re-silced the same part and it would shift. deleted Sil3er reinstalled and the shifting stopped. hope this helps.by nique911 - General
Don't know if this will but I was having a problem with my servo when LCD was hooked up, Ramps could not handle it. what I did was installed a 7805 voltage regulator. now it has all the juice it needs. Here is what I did: close to bottom of page. good luckby nique911 - Printing
Hey if you guys are looking for something to do with the 608 bearings that come with the kit. By by PristineSource I built it but have not installed it yet Very well built just be careful when tightening the M8 bolt.by nique911 - Prusa i3 and variants
Sorry wrong thead.by nique911 - Prusa i3 and variants
Quotecheaptrick2 Hello there! I have recently got my Folgertech prusa i3 up and running, and I am a very happy camper. I have seen the amazing upgrades, and I want to install an automatic bed leveling system. I have no trouble with printing the parts, and ordering the servo motor, however I need to know where I can find a servo mount file or kit for their strange closed off-injection molded-direcby nique911 - Prusa i3 and variants
Quotebengele Hoping that someone who is better at electronics can verify what I am going to do. I am trying to follow Tom's Guide on setting up auto bed leveling 3D printing guides: Setting up auto bed tramming leveling tilt compensation! I am going to just use the open terminals on the power supply to get 12v input and ground. It looks to me like the pin closest to the edge of the ramps boardby nique911 - Prusa i3 and variants
I used a fresh copy of Marlin and followed SteveRoy's Instructable page His page was a BIG help.by nique911 - Prusa i3 and variants
there is a line in configuration h around line 607 #define DEFAULT_LCD_CONTRAST 17 ( I have never touched it) but may be worth a shot.by nique911 - Prusa i3 and variants
Adjustable resistor on front left. use the screw driver that came with the kit. sorry just looked at your pic. check the back, mine has adjustment on front. got it from folger.by nique911 - Prusa i3 and variants
here are a couple you might want to use. VREFS Steve Roy's write up helped a lot. Steps per millimeter calculator The Arduino link Here is a neat one if anyone is looking for a 3D scanner, you make it out of an XBox Kinects. (I got the Kinects off ebay for $40.00 but have not tried it yet.) Here is a Calibration Guideby nique911 - Prusa i3 and variants
Try adjusting the contrast (with the adjustment on the front of the board)by nique911 - Prusa i3 and variants
This is the pair I got work wellby nique911 - Prusa i3 and variants